- Digital control, up to 300℃
- Bead Capacity: 300g
- Heating Time: 25min(RT. to 300°C)
- Temp accuracy: 土5℃
-
-
- Heating steps: 9 steps
- Temperature range (nominal Temperature): 20℃~3000℃
- Slope heating time: 0~999s
- Heating holding time: 1s~999s (the sum of both time should be less than 999 seconds)
- Inert gas needed: argon, pressure of entry larger than 0.3Mpa
- Cooling water: tap water or cycling water, flow rate no less than 2L/min
-
- Resolution: 0.001,0.01,0.1,1
- Accuracy: ±1% F.S
- Calibration Points: 2 to 5 points (0.01, 0.1, 1, 10, 100mmol/L)
-
- 2 to 5 points calibration
- For water hardness and temperature
- Stores or recalls up to 500 data sets
- 5 kinds of water hardness units
-
- lon Range: 0.001-30000
- Accuracy: ±0.5% F.S. (monovalent), ±1% F.S. (divalent)
- mV Range: ±2000.0mV
-
- 1 to 3 points calibration,
- Selectable TDS conversion factor
- Setup menu contains 5 options
- Accuracy: 1% F.S.
-
- Accuracy: ±1% F.S.
- Calibration Points: 1 point
- Suitable for measuring the low concentration liquids
-
- Accuracy ±1% F.S.
- Calibration Point 1 point
- Suitable for general application
-
- 1 point calibration.
- Auitable for measuring the high concentration liquids
- Accuracy: 1% F.S.
-
- Detector: NDIR
- Parameters: TC, TIC, TOC, NPOC
- Measurement Range: 0-1000mg/L
- Detection Limit: TC: 50μg/L IC: 20μg/L
- Repeatability: ≤3%
- Digestion Mode: High Temperature Combustion
-
- Detector: NDIR
- Parameters: TC, TIC, TOC, NPOC
- Measurement Range: 0-10000mg/l (ppm)
- Detection Limit: 50μg/l (ppb)
- Gas Requirement: Nitrogen ≥99.995%
- Automatic leaking check system
- Flow rate controlling system
- Method: Wet Chemical Oxidation by UV
-
- Conductivity (Off-line)
- Test items: TOC
- Detection Range: 0.001-1.5mg/l(ppm)
- Detection limit: 1 ppb
- Analysis time: 3 min
- Sample flow speed: 1 ml/min
- Continuous sample feed
- For microelectronics water,purified water, water for injection
-
- Conductivity (On-line)
- Parameters: TOC
- Detection Range: 0.001-1.5mg/l(ppm)
- Detection limit: 1 ppb
- Analysis time: 3 min
- Sample flow speed: 1 ml/min
- Continuous sample feed
- For microelectronics water,purified water, water for injection
-
- Suitable for Android smartphone or tablet
- 2 to 5 points calibration
- Setup menu contains 12 options
- Accuracy: 1% F.S
-
- ORP mV Range: ±999mV
- Resolution: 1mV
-
- Max speed/RCF: 5000RPM/4390×g
- Max capacity: 15ml×36
Get Social